Corrections
One-Yard Wonders
Encase the upper raw edge . . . Position the two back pieces, right sides up, so that the lower piece overlaps the upper piece by 4”. Baste together. . .
Waistband: 17 1/2” wide x 5” tall (cut 1 on fold)
Apron trim: 6 1/2” x 1 1/2” (cut 2 on bias)
Place the apron front on top of the apron back with both wrong sides facing up, matching the notches at the top edge, and pin in place. Press one long edge of the apron trim 1/2" to the wrong side. Position the right side of the apron trim on the wrong side of the stacked apron front and back pieces. Raw edges of the apron trim will align with side edge of the stacked apron front and back pieces. Note that the apron trim will overlap the apron front by 1". Stitch through all layers around the curved edge of the apron, leaving the top notched edge open.
Trim entire seam allowance to 1/4". Clip to but not through through the seam along the rounded corners to ease fullness. Turn the apron right side out and press curved edges. Fold the apron trim to the front. Press and pin trim in place, ensuring that it covers the trimmed seam allowance. Topstitch around the finished curved edge of apron at 1/2", making sure to catch the edges of the apron trim. Match notches at top edge of apron and baste in place using a scant 1/4" seam from pocket edge to pocket edge.
Click here for corrected table/chart PDF
Change to illustration. Please see PDF.
Please note that the text for the oven mitt pattern piece is upside down.
Please note that the text for the BODY pattern piece is upside down.
Encase one wide (top) edge. . . From the top, mark the body piece as shown along both long sides at 10” and again at 14 1/2”. . . attaching the side pieces.
With wrong sides together. . . Pin in place and stitch to the 10” mark. . . Do the same with the second side piece.
Bottoms: 6 1/2” diameter circle (cut 2)
Lining:
11”
tall x 12” wide (cut 2)
Top band: 3 1/2” tall x
11”
(cut 4)
With right sides together and raw edges aligned, stitch one top band piece to one lining piece along the 11” edge. Repeat for the remaining top band and lining pieces.
Click here for corrected table/chart PDF
Change to illustration. Please see corrected PDF.
Click here for corrected table/chart PDF
Correction to pattern piece. Please see PDF mockup.
Please note that the text on these tissue paper pattern pieces for this pattern are upside down:
TOP BAND, LINING FRONT/BACK, and BAG FRONT/BACK
Please note that the text for this pattern piece is upside down.
Click here for corrected table/chart PDF
Change to illustration. Please see PDF.
Bias strip (for binding) 2” x
62” *
Bias strip (for piping) 1” x 32”
*
*The bias strips will be cut from the remaining middle section of fabric. You will need to piece the strips together in Step 3 to achieve the necessary finished lengths.
Large interior/exterior: 22” tall x 8” wide (cut 2)
Kite: Measure and cut as shown from a 24” x 24” square (cut 1)
Please note that the text on the tissue paper pattern piece for the BODY is upside down.

